Corvette is not level
Thread Starter
1st Gear
Joined: Aug 2011
Posts: 1
Likes: 0
Corvette is not level
I'm working on a 1974 corvette. The whole right side is lower than the left. I've changed the shocks, springs, lower ball joints and as suggested checked the bushings and they were OK. I welcome any and all help with this problem. Ron
Team Owner
Joined: Sep 2006
Posts: 31,301
Likes: 4,389
From: Westminster Maryland
Hi Ron,
Have you tried to get a look at the body mounts? Or is that what you meant by 'bushings'.
If they're extremely deteriorated that could allow the body to sag on one side.
How much is the difference and did you notice any problem before you began your refurbishment?
Regards,
Alan
Have you tried to get a look at the body mounts? Or is that what you meant by 'bushings'.
If they're extremely deteriorated that could allow the body to sag on one side.
How much is the difference and did you notice any problem before you began your refurbishment?
Regards,
Alan
Le Mans Master
Joined: Jun 2007
Posts: 7,666
Likes: 1
From: Where it's always hot as Hell-South Louisiana.
St. Jude Donor '07-'08-'09-'10-'11-'12-'13
check out this link.
Does this look like your problem ?
http://forums.corvetteforum.com/c3-t...-80-model.html
My problem was ultimately solved by replacing the body mounts. Drivers side mounts were flat from age, and had zero or 1 shim each mount. Pass side mounts were NOT flat and had 4 or 5 shims each. The assembly line people must have been drunk that day ???
http://forums.corvetteforum.com/c3-t...-80-model.html
My problem was ultimately solved by replacing the body mounts. Drivers side mounts were flat from age, and had zero or 1 shim each mount. Pass side mounts were NOT flat and had 4 or 5 shims each. The assembly line people must have been drunk that day ???
Last edited by mikejpss; Aug 21, 2011 at 09:14 AM.
