When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Doing front end on my 71. All safety measures in place for coil spring removal. Got all off except for rotor assembly that attaches to upper and lower ball joints. I've tried pickle bar with no budging. Any suggestions at this point would help.
You can whack the flat edge were the ball joint slides into the spindle. I usually leave the nut on the ball joint loose and using the spring load on the ball joint to pop it apart. If you have the spring out, use a little heat and beat the **** out of it with a pickle fork. You won't be ruining anything you're not replacing anyway.
I know what you are going through. Just did that about 2 weeks ago. I used aft/acetone mix and soaked it for two days. Then used Harbor Freight balljoint separator tool. That worked, but still came apart hard. It went together in December of 1970, and was reluctant to come apart. Good luck.
Doing front end on my 71. All safety measures in place for coil spring removal. Got all off except for rotor assembly that attaches to upper and lower ball joints. I've tried pickle bar with no budging. Any suggestions at this point would help.
Make sure you're using a ball joint separator and not the smaller tie rod end separator. The small fork will hang on the width of the ball joint stud preventing you from driving it in far enough to wedge the rotor joint off of the ball joint stud.
Make sure you're using a ball joint separator and not the smaller tie rod end separator. The small fork will hang on the width of the ball joint stud preventing you from driving it in far enough to wedge the rotor joint off of the ball joint stud.
I think fork is small for this job. I'll try to squeeze open end wrench in there tomorrow. Or I'll get larger ball joint toll. Annoying.
I just did this about three weeks ago. The bottom joint was tough, work on getting the upper to break loose, get the knuckle off, after getting spring out, and then you can work on the lower on your work bench.
Ok. Got them all off! With the help of forum members. Got the tool from Harbor Freight as directed. Uppers not to bad. Lowers were real hard. Took within an inch of the tools life but they finally popped. Had to relocate tool several times. No pounding what so ever involved. Forget pickle fork. Use this tool is lots easier. Now to get lower control arm bolts off.
Ball Joints
