FS: FS Cross bar for five point harnesses
07-17-2022, 08:40 PM
#1
Race Director
Thread Starter
FS Cross bar for five point harnesses
I bought this R&D Cross bar on here awhile back and paid 300 IIRC. I didn't use it and should let it go for someone else to use. 300 Shipped,
I would prefer Venmo but check paypay etc work too.
I would prefer Venmo but check paypay etc work too.
07-21-2022, 11:17 PM
#3
Race Director
Thread Starter
That's a good question. I had it for my '88 and can do some research about it fitting later years.
07-25-2022, 10:05 AM
#5
Race Director
Thread Starter
Got your PM writing you back to be sure.
07-25-2022, 10:11 AM
#6
Race Director
Thread Starter
PM sent. I read the bar fits 84-90E and a different bar fits 90L-96 but I can't find anything on the differences.
07-25-2022, 11:34 AM
#7
Instructor
Here's the picture I saw of one installed in a 91+ if that helps, maybe the end link or bar span is different?
https://www.corvetteforum.com/forums...tructions.html
So I'll back off then so someone with 84-90 can buy if this matches that application. thanks!
https://www.corvetteforum.com/forums...tructions.html
So I'll back off then so someone with 84-90 can buy if this matches that application. thanks!
07-25-2022, 11:45 AM
#8
Race Director
Thread Starter
I'll take some pix with a tape measure across the mounting points in a few min.
07-25-2022, 02:00 PM
#9
Race Director
Thread Starter
These help any? First is total length then the flanges.
07-25-2022, 02:28 PM
#10
Instructor
on my '93
- 48" should be fine for bar width
- its approximately 12" distance from seat belt mount on integrated roll bar (top) to targa bracket on floor (bottom) hole is
so without enlisting my son to do the trigonometry to convert 4" and 9" and 1" bar (?) to see if + 12", my 'guess' would be the bar and more complicated roll bar (top) bracket are same both years, and the bottom simpler strap was probably adjusted slightly different length or bends or both for any difference in height or mounting position of targa bracket?
So might be perfect fit or might need slight adjustment / fabrication on the lower strap/bar, is again my guess. But probably also only coupe, convertable way different top belt bracket?
Since Kevova asked first I'll defer to him if he wants it.
If Kevova doesn't want it I'll take it. Cheers
- 48" should be fine for bar width
- its approximately 12" distance from seat belt mount on integrated roll bar (top) to targa bracket on floor (bottom) hole is
so without enlisting my son to do the trigonometry to convert 4" and 9" and 1" bar (?) to see if + 12", my 'guess' would be the bar and more complicated roll bar (top) bracket are same both years, and the bottom simpler strap was probably adjusted slightly different length or bends or both for any difference in height or mounting position of targa bracket?
So might be perfect fit or might need slight adjustment / fabrication on the lower strap/bar, is again my guess. But probably also only coupe, convertable way different top belt bracket?
Since Kevova asked first I'll defer to him if he wants it.
If Kevova doesn't want it I'll take it. Cheers
07-25-2022, 03:17 PM
#13
Race Director
Thread Starter
Okay thanks guys! Checking PM.