LT4 info needed
Thread Starter
Drifting
Joined: Jan 2001
Posts: 1,669
Likes: 1
LT4 info needed
Does anyone know or may have information on installing a LT4 intake in an L98 engine. What I am looking for is how they drilled and machined for the distributor. I have seen this topic on here with pics of a intake that was done and I need to see the pics again or some technical info on it.
Thanks
Thanks
Race Director
Joined: Jul 2000
Posts: 11,007
Likes: 1
From: Probably in the paint booth....
Re: LT4 info needed (snaketr)
There is a web page somewhere explaining how to do it. I know the guy had to make a special washer to fit between the dist. & the intake. The intake alone is too low where the dist. hole goes. I'll see if I have it bookmarked somewhere in my mess I call Explorer.
Neal
Neal
7th Gear
Joined: Jun 2002
Posts: 7
Likes: 0
From: olivehurst ca
Re: LT4 info needed (snaketr)
lt4's heads are raised runner. The intake runners on the lt4 intake would not match up to your L98 heads intake runners. An lt1 intake however may work if you work out the dist. clearance...never really thought about it.
Burning Brakes
Joined: Apr 2002
Posts: 934
Likes: 0
From: MO
