When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have a new style (01-04) TPMS receiver ready to install - I've isolated the pins needed to connect to my older harness according to a thread I saw on here and it's ready to go, except - where is it?
From searching on here, it seems to be on the driver's side, but I don't know what panels to take off. Only thing I've found so far is a silver Antenna Receiver Module on the b-pillar.
I see a "hump" on one of the cargo trim panels but can't figure out how to remove the panel without breaking it (or if that's even what I'm looking for).
Actually #3 is the receiver module I was asking about. It has a plastic rod going through the module with foam disks at either end of the rod. I think it's to hold it in place - it's literally under a plastic panel held on by double-sided tape, but I didn't look at it that closely.
#2 is something else - maybe a crash sensor/module?
From: Dear Karma, I have a list of people you missed.
St. Jude Donor '08-'09-'10-'11-'12-'13-'14-'15-'16
Originally Posted by steelels1
Actually #3 is the receiver module I was asking about. It has a plastic rod going through the module with foam disks at either end of the rod. I think it's to hold it in place - it's literally under a plastic panel held on by double-sided tape, but I didn't look at it that closely.
#2 is something else - maybe a crash sensor/module?
That "plastic rod" is the antenna. Two of them actually. Each pointing in a different direction. The little foam disks are there to prevent the two antennas from wiggling/vibrating against the body panel and making any noise.