ABS and Traction
#1
ABS and Traction
Was driving down the road legal speed and my service ABS and Traction Control came on the computer indicator. After stopping and then restarting the indication did not come back on. I have a 2000 model. Any info will help.
#3
Tech Contributor
Member Since: Dec 1999
Location: Anthony TX
Posts: 32,736
Received 2,180 Likes
on
1,583 Posts
CI 6,7,8,9,11 Vet
St. Jude Donor '08
Pull and post the DTCs so we can logically assist you.
The following users liked this post:
Jazzyjam (11-02-2021)
#5
7th Gear
My 2000 is doing the same- intermittent ABS/Traction control error- Code C1226- Pre the BlueDriver code reader app it is saying.
Faulty Front Hub Assy
Faulty Front wheel speed sensor
Faulty Front wheel speed harness.
Faulty Front Hub Assy
Faulty Front wheel speed sensor
Faulty Front wheel speed harness.
#6
Tech Contributor
Member Since: Dec 1999
Location: Anthony TX
Posts: 32,736
Received 2,180 Likes
on
1,583 Posts
CI 6,7,8,9,11 Vet
St. Jude Donor '08
For the most part when ever you have a WSS DTC for the front wheel signal data, its caused by damaged/ spread apart electrical connector FEMALE PINS. There are TWO female pin connectors for each front wheel. One on the Jumper Harness connector and one on the main WSS harness on the Frame.
Examine the female pins and look for damaged female pins that will be spread apart. Do a pin PUSH PULL TEST for every female pins and repair /replace any that fail.
Examine the female pins and look for damaged female pins that will be spread apart. Do a pin PUSH PULL TEST for every female pins and repair /replace any that fail.
The following users liked this post:
TCFS (08-02-2021)