C7 headlights modification
#421
The following 4 users liked this post by centennialGS:
The following 2 users liked this post by Crazy Cowboy:
badhabit_wb (10-20-2017),
Biggie G (11-28-2017)
#423
Premium Supporting Vendor
Thread Starter
Member Since: Nov 2003
Location: www.EXOTICVETTE.com - FL Cruise-In VI, VII, & VIII
Posts: 6,853
Received 120 Likes
on
91 Posts
Cruise-In V Veteran
St. Jude's Donor '05-'06-'07-'08-'09-'10-'11-'12-'13-'14-'15-'16
For any of you guys looking to order a kit I can get it out by the end of this coming week but I have Sema coming up next week after that so you would be looking at about three weeks.
#424
Le Mans Master
Terrific work. If my car gets body damage I’m all over this front and rear.
#425
Premium Supporting Vendor
Thread Starter
Member Since: Nov 2003
Location: www.EXOTICVETTE.com - FL Cruise-In VI, VII, & VIII
Posts: 6,853
Received 120 Likes
on
91 Posts
Cruise-In V Veteran
St. Jude's Donor '05-'06-'07-'08-'09-'10-'11-'12-'13-'14-'15-'16
Thanks BadBirdCage.
Just for this week, I will offer the next two customers who want the bumper cap conversion that’s normally $2000 a pre-SEMA sale price of $1700 plus shipping. That’s $300 off until Friday! ONE WEEK ONLY
This will include the harnesses, headlight mounting buckets, panel bond, hardware / brackets, fender panels and front bumper cap replacement top half. This will work on ANY C6. Widebody or base model. It requires very VERY little time to install and bodywork the bumper. A sawzall to cut the front bumper down the middle takes about 30 seconds and then panel bond the top bumper half to the original lower. Then you can either bodywork the seams blended in near the foglights or you can make the bodylines nice and clean before glueing the cap on which would mean no blending the pieces.
This also gives your base model a factory widebody Z06/Zr1 bumper vent along with the C7 headlight conversion.
Give us a call or email for more info. The below pics show the bumper cap with the only areas needing body work circled in pink. We have had one customer who cleaned the lines to line up with the fog light and side reflector nice and thin and straight which looks nice and zero bodywork to the bumper edges.
Just for this week, I will offer the next two customers who want the bumper cap conversion that’s normally $2000 a pre-SEMA sale price of $1700 plus shipping. That’s $300 off until Friday! ONE WEEK ONLY
This will include the harnesses, headlight mounting buckets, panel bond, hardware / brackets, fender panels and front bumper cap replacement top half. This will work on ANY C6. Widebody or base model. It requires very VERY little time to install and bodywork the bumper. A sawzall to cut the front bumper down the middle takes about 30 seconds and then panel bond the top bumper half to the original lower. Then you can either bodywork the seams blended in near the foglights or you can make the bodylines nice and clean before glueing the cap on which would mean no blending the pieces.
This also gives your base model a factory widebody Z06/Zr1 bumper vent along with the C7 headlight conversion.
Give us a call or email for more info. The below pics show the bumper cap with the only areas needing body work circled in pink. We have had one customer who cleaned the lines to line up with the fog light and side reflector nice and thin and straight which looks nice and zero bodywork to the bumper edges.
#426
Premium Supporting Vendor
Thread Starter
Member Since: Nov 2003
Location: www.EXOTICVETTE.com - FL Cruise-In VI, VII, & VIII
Posts: 6,853
Received 120 Likes
on
91 Posts
Cruise-In V Veteran
St. Jude's Donor '05-'06-'07-'08-'09-'10-'11-'12-'13-'14-'15-'16
Holidays are here guys. 10% off on any C67 conversion kit ordered this week! I’m out of town this week for the holiday buy you can call 407-221-8040 or email sales@exoticvette.com for more info
#427
Holidays are here guys. 10% off on any C67 conversion kit ordered this week! I’m out of town this week for the holiday buy you can call 407-221-8040 or email sales@exoticvette.com for more info
#429
Premium Supporting Vendor
Thread Starter
Member Since: Nov 2003
Location: www.EXOTICVETTE.com - FL Cruise-In VI, VII, & VIII
Posts: 6,853
Received 120 Likes
on
91 Posts
Cruise-In V Veteran
St. Jude's Donor '05-'06-'07-'08-'09-'10-'11-'12-'13-'14-'15-'16
I want to say thank you to the three members who purchased yesterday. Just a reminder that the sale ends tonight, Tuesday, at midnight. Don’t miss out on this opportunity to save hundreds of dollars which may not happen again!
#430
Premium Supporting Vendor
Thread Starter
Member Since: Nov 2003
Location: www.EXOTICVETTE.com - FL Cruise-In VI, VII, & VIII
Posts: 6,853
Received 120 Likes
on
91 Posts
Cruise-In V Veteran
St. Jude's Donor '05-'06-'07-'08-'09-'10-'11-'12-'13-'14-'15-'16
We got a little slowed down by this insane cold weather this past week. Too cold to make parts!
I am going to update the web page soon to be less confusing as to the different kits we have available. We are probably going to discontinue the lowest level $1500 basic front kit and only offer two options - the front bumper cap conversion for narrow body cars ($2000) and the front widebody bumper/fender replacement kit ($3000). The best part about the replacement parts widebody if you can make your narrow body car a widebody with just rear quarter (which we just found a source for at a very reasonable price) or if you have a widebody already you can sell your stock widebody fenders and bumper for probably the same price as the conversion kit if they are in good condition!
The rear replacement bumper is $1500.
We have about a 2 week ship time right now because of the cold weather putting us backed up this week - so if you want to do a C67 conversion soon you better order NOW!
CLICK HERE FOR INFO AND ORDERING!
I am going to update the web page soon to be less confusing as to the different kits we have available. We are probably going to discontinue the lowest level $1500 basic front kit and only offer two options - the front bumper cap conversion for narrow body cars ($2000) and the front widebody bumper/fender replacement kit ($3000). The best part about the replacement parts widebody if you can make your narrow body car a widebody with just rear quarter (which we just found a source for at a very reasonable price) or if you have a widebody already you can sell your stock widebody fenders and bumper for probably the same price as the conversion kit if they are in good condition!
The rear replacement bumper is $1500.
We have about a 2 week ship time right now because of the cold weather putting us backed up this week - so if you want to do a C67 conversion soon you better order NOW!
CLICK HERE FOR INFO AND ORDERING!
The following 2 users liked this post by enventr:
Crazy Cowboy (02-01-2018),
Maxie2U (01-27-2018)
#432
Premium Supporting Vendor
Thread Starter
Member Since: Nov 2003
Location: www.EXOTICVETTE.com - FL Cruise-In VI, VII, & VIII
Posts: 6,853
Received 120 Likes
on
91 Posts
Cruise-In V Veteran
St. Jude's Donor '05-'06-'07-'08-'09-'10-'11-'12-'13-'14-'15-'16
$3000 plus shipping or free pickup locally in Central FL for the replacement bumper and fender kit for your Z06, Zr1, Grand Sport. The fenders are Z06 style side vents. These will fit a narrow body but you will need some trim pieces and wheel well liners for the widebody (as well as widebody rear quarters if you don’t have them already). We have a source for rear aftermarket widebody quarters much cheaper than OEM also.
Or bring us the car and we will paint and install it for you cheaper than anyone else will.
All you need is a C6 and some C7 headlights!
Or bring us the car and we will paint and install it for you cheaper than anyone else will.
All you need is a C6 and some C7 headlights!
#434
Premium Supporting Vendor
Thread Starter
Member Since: Nov 2003
Location: www.EXOTICVETTE.com - FL Cruise-In VI, VII, & VIII
Posts: 6,853
Received 120 Likes
on
91 Posts
Cruise-In V Veteran
St. Jude's Donor '05-'06-'07-'08-'09-'10-'11-'12-'13-'14-'15-'16
Bolt on fenders in this pic:
And the first narrowbody bumper cap conversion which includes the Z06 vent
Kits in stock usually or built within a week. Call us for pricing and availability on installs and painted installs.
www.ExoticVette.com 407-221-8040
And the first narrowbody bumper cap conversion which includes the Z06 vent
Kits in stock usually or built within a week. Call us for pricing and availability on installs and painted installs.
www.ExoticVette.com 407-221-8040
#436
headlights
Okay. I admit I like the looks of the C7 lights on the C6, but if you're going to change out the front end, the *** end, and make it LOOK like a C7, why not just suck up the cost and buy a C7?? C6's are C6's and C7's are C7's. Crossbreeding brings some weird freaks out.
How many people have bought a new car or truck and first thing they do is add something like tags or fog lights or seat covers even spoilers , its same to each his own as for me he had done a great job doing this and helping us get it done , Thanks Cowboy .....
#437
Pro
I've always thought that the stock headlights were lacking something. I love my C6, but this kit looks like just what the doctor ordered for my take on those headlights. I will be doing this in the near future.
#439
headlights
i bought the buckets from him but i put on c7 fenders if you want the buckets ill sell the kit for $200
#440
Pro