Question about engine swap.
Thread Starter
1st Gear
Joined: Feb 2025
Posts: 1
Likes: 0
Question about engine swap.
I am looking at a C6 that does not have motor or trans. Very nice car overall.
I built a 6.2 from an 07 Denali for a different project, then changed my mind. Can I use the ecm/bcm/tcm from this C6 and put my 6.2 in the car? I know I would need it tuned, just need to know if I need a new ecm or not.
Thanks in advance.
Mike
I got the info needed. 👍
I built a 6.2 from an 07 Denali for a different project, then changed my mind. Can I use the ecm/bcm/tcm from this C6 and put my 6.2 in the car? I know I would need it tuned, just need to know if I need a new ecm or not.
Thanks in advance.
Mike
I got the info needed. 👍
Last edited by Tx_Mike72; Feb 9, 2025 at 06:30 PM.
Le Mans Master
Joined: Dec 2013
Posts: 6,338
Likes: 5,115
From: Charles Town WV
2024 Corvette of the Year Finalist - Modified
2023 C6 of the Year Winner - Modified
2022 C6 of the Year Finalist - Modified
I am looking at a C6 that does not have motor or trans. Very nice car overall.
I built a 6.2 from an 07 Denali for a different project, then changed my mind. Can I use the ecm/bcm/tcm from this C6 and put my 6.2 in the car? I know I would need it tuned, just need to know if I need a new ecm or not.
Thanks in advance.
Mike
I got the info needed. 👍
I built a 6.2 from an 07 Denali for a different project, then changed my mind. Can I use the ecm/bcm/tcm from this C6 and put my 6.2 in the car? I know I would need it tuned, just need to know if I need a new ecm or not.
Thanks in advance.
Mike
I got the info needed. 👍
Yep, shouldn't be an issue at all. If its an iron block some sensors may be located a little differently but all stuff thats easy to fix. If its an aluminum it should pretty much be plug and play (tune withstanding). You'll need a Corvette front drive assembly and balancer though, truck stuff sets out way too far.
