When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
custom job for now probably, any reputable place should be able to put and stretch the pieces i am not sure if the Xpel website list the custom machined cuts yet or not
I had an XPEL clear bra put on mine last week. I have bubbles on my lower front bumper due to the angles; I have already taken it back once and have to go in again. The pictures below are from two different times.
I had an XPEL clear bra put on mine last week. I have bubbles on my lower front bumper due to the angles; I have already taken it back once and have to go in again. The pictures below are from two different times.
That's not what I would expect!
Guess I will not be getting a clear bra!
That's not what I would expect!
Guess I will not be getting a clear bra!
Those bubbles are where the installer did not heat the film down. The C7 is a much easier car to install film on than the C6. Find a good installer and you wont have any issues.
Has anyone had the Xpel installed while getting museum delivery?
It is an option I am considering, and while more expensive it appears, at least I'll have some protection on the car for the drive home, especially this time of year.
GM will be releasing a clear bra product for the C7 available as a Genuine Corvette Accessory (GCA) product and it will be available via the dealer network. You will likely be able to find it through the GM Accessory Zone website when available.
Had a clear bra put on about 2 weeks ago using the Xpel. Did front nose, 24" up on the hood, mirrors, and rocker panels. The installer did an flawless job.
I had museum delivery oct 21. At that time they were not able to do a clear bra, because they were too busy with deliveries. That may have now changed.
GM will be releasing a clear bra product for the C7 available as a Genuine Corvette Accessory (GCA) product and it will be available via the dealer network. You will likely be able to find it through the GM Accessory Zone website when available.
Those bubbles are where the installer did not heat the film down. The C7 is a much easier car to install film on than the C6. Find a good installer and you wont have any issues.
I used the official XPEL dealer in Houston. If they don't know who will.
Is 30 days a reasonable time to wait before installing xpel due to paint curing? Going to do front end wrap on AW.
My dealer uses a local installer who used a 3M product, I am very satisfied with it and these guys know what they are doing. 300 miles on vin #368 and so far no problems with my car that was in Nashville for four weeks. Mike
Designer Imagines A Corvette That Looks More Like a Corvette Than the Corvette
Slideshow: A Jaguar designer's personal project imagines what a modern front-engined Corvette might look like if Chevrolet revisited the golden age of the Stingray.