CorvetteForum - Chevrolet Corvette Forum Discussion
Fond memories. Thinking about making end tables of them.
Fond memories. Thinking about making end tables of them.
0 2023/09/19 05:49:16
I disconnected the rear line at the distribution block and coupled it to a new line to the master cylinder. Then put a plug in the distribution block. I can easily revert back to the original master cylinder.
I disconnected the rear line at the distribution block and coupled it to a new line to the master cylinder. Then put a plug in the distribution block. I can easily revert back to the original master cylinder.
0 2023/09/20 06:12:58
I believe this is the stock tab for the accelerator spring on a 66 300hp / 327. Don't know if it is right for yours.
I believe this is the stock tab for the accelerator spring on a 66 300hp / 327. Don't know if it is right for yours.
0 2023/09/20 06:13:00
0 2023/09/20 06:35:49
0 2023/09/20 06:36:38
0 2023/09/20 06:36:56
0 2023/09/20 06:36:57
0 2023/09/20 06:38:24
GM Muncie 318 3 spd: Case: GM12 384522 C165 12 4 Tail Shaft: 2 3707195 4 bolt Cover: 3845044
GM Muncie 318 3 spd: Case: GM12 384522 C165 12 4 Tail Shaft: 2 3707195 4 bolt Cover: 3845044
0 2023/09/20 06:51:46
0 2023/10/01 05:21:07
0 2023/10/01 05:21:23
Original camber adjustment bolt / washer R66
Original camber adjustment bolt / washer R66
0 2023/10/01 05:21:37
0 2023/10/01 05:33:00
0 2023/10/01 05:33:08
Gen 1 Camaro door handle.
Gen 1 Camaro door handle.
0 2023/10/28 13:47:00
10 pin connector - 60s? engine harness.
10 pin connector - 60s? engine harness.
0 2023/11/02 14:16:42
O-ring fit loosely on a tapered drift pin or punch. Measure at the bottom of the O-ring and top and average the reading.
O-ring fit loosely on a tapered drift pin or punch. Measure at the bottom of the O-ring and top and average the reading.
0 2023/11/04 14:42:23
O-ring still loosely on the drift pin. Measure the O.D. Light touch needed.
O-ring still loosely on the drift pin. Measure the O.D. Light touch needed.
0 2023/11/04 14:42:36
Rag Tops are my flavor since 1965.
Rag Tops are my flavor since 1965.
0 2023/11/06 09:00:08
Not a Restomod, just fun in the sun or rain.
Not a Restomod, just fun in the sun or rain.
0 2023/11/06 09:01:03
0 2023/11/12 17:50:27
Bonding strip LF fender
Bonding strip LF fender
0 2023/11/20 11:21:46
Bonding strip LF fender
Bonding strip LF fender
0 2023/11/20 11:22:03
Driver's side
Driver's side
0 2023/11/20 14:14:17
Passenger's side
Passenger's side
0 2023/11/20 14:14:50
DS front
DS front
0 2023/11/20 18:56:36
PS front
PS front
0 2023/11/20 18:56:53
0 2023/11/30 05:20:23
Figured I would follow the instructions this time.
Figured I would follow the instructions this time.
0 2023/11/30 18:14:10
1/4" x 1" aluminum bar added.
1/4" x 1" aluminum bar added.
0 2023/12/08 19:03:33
Good fit to air cleaner. Might use a little longer hose, but works as is.
Good fit to air cleaner. Might use a little longer hose, but works as is.
0 2023/12/08 19:03:52
Radiator hose cut to fit.
Radiator hose cut to fit.
0 2023/12/08 19:04:33
0 2023/12/11 05:59:55
0 2023/12/14 07:25:15
Early 60s style connector housing with male pawl and female loop.
Early 60s style connector housing with male pawl and female loop.
0 2023/12/14 07:26:15
1968 connector with a single bolt to hold the assembly tight. Also dielectric grease from the factory. Not sure about 67 vehicles
1968 connector with a single bolt to hold the assembly tight. Also dielectric grease from the factory. Not sure about 67 vehicles
0 2023/12/14 07:27:28
0 2024/01/05 13:12:41
0 2024/01/09 04:02:59
Chevy Internal valve cover baffle
Chevy Internal valve cover baffle
0 2024/01/17 06:35:57
VC baffle fits between rocker arms / valves
VC baffle fits between rocker arms / valves
0 2024/01/17 06:36:21