CorvetteForum - Chevrolet Corvette Forum Discussion
660 switch and connector
660 switch and connector
0 2020/05/07 15:32:54
68RS mounting at the front.
68RS mounting at the front.
0 2020/01/10 09:58:41
68RS Camaro mounting, The bracket is basically the same, but curved to clear the manifold runner and lower the alternator. These are not sheep horn manifolds
68RS Camaro mounting, The bracket is basically the same, but curved to clear the manifold runner and lower the alternator. These are not sheep horn manifolds
0 2020/01/10 09:56:28
This will put the alternator in the right place. Notice the front bolt hole is slotted but not the rear.
This will put the alternator in the right place. Notice the front bolt hole is slotted but not the rear.
0 2020/01/10 09:53:56
60s sheep horn Chevy Drivers side
60s sheep horn Chevy Drivers side
0 2020/01/10 09:53:48
Cable bolted to exhaust manifold bolt hanging loose.
Cable bolted to exhaust manifold bolt hanging loose.
0 2019/12/26 08:26:48
Won't work if Godzilla is at the wheel and breaks the cable or 3/8" bolt, but I also have a 'CLUB' on the steering wheel that they will use bolt cutters on.
Won't work if Godzilla is at the wheel and breaks the cable or 3/8" bolt, but I also have a 'CLUB' on the steering wheel that they will use bolt cutters on.
0 2019/12/26 08:25:48
Wheels turned fully to the left and cable loop installed over the bolt in the coupler and then the flanged nut installed. I found the nut is not necessary, but not much trouble.
Wheels turned fully to the left and cable loop installed over the bolt in the coupler and then the flanged nut installed. I found the nut is not necessary, but not much trouble.
0 2019/12/26 08:25:41
0 2019/12/26 08:24:04
0 2019/12/05 18:18:56
0 2019/12/05 18:18:29
Wind raked back yard - I don't have to do the 4th pass with the leaf vac.
Wind raked back yard - I don't have to do the 4th pass with the leaf vac.
0 2019/11/28 14:15:44
Leaf Block - page wire fence
Leaf Block - page wire fence
0 2019/11/28 14:14:49
Magnetic level on the guage helps.
Magnetic level on the guage helps.
0 2019/11/27 08:12:24
Caster guage in use - must be plumb both directions.
Caster guage in use - must be plumb both directions.
0 2019/11/27 08:12:16
Water level made from 10 feet of 3/8" vinyl tubing, 2ea 90 deg elbows, and scrap wood routed for tubing. Water is dyed blue. I also use it to level my pool table.
Water level made from 10 feet of 3/8" vinyl tubing, 2ea 90 deg elbows, and scrap wood routed for tubing. Water is dyed blue. I also use it to level my pool table.
0 2019/11/27 07:32:18
Slip pads - 2 pcs of plastic or metal with zip lok bag filled with 5 or 6 shots of chassis grease. One under each wheel
Slip pads - 2 pcs of plastic or metal with zip lok bag filled with 5 or 6 shots of chassis grease. One under each wheel
0 2019/11/27 07:32:05
Sliding end of caster guage (square with threaded rod) to measure difference between upper and lower ball joint centers - and calculate caster.
Sliding end of caster guage (square with threaded rod) to measure difference between upper and lower ball joint centers - and calculate caster.
0 2019/11/27 07:31:38
Fixed end of caster guage. Must be square with threaded rod.
Fixed end of caster guage. Must be square with threaded rod.
0 2019/11/27 07:31:26
Caster guage hooks on upper and lower ball joint zerks. Adjustable 1/2" threaded rod to work on Camaro or Vette. A PIA to hold plumb in two directions while obtaining measurement.
Caster guage hooks on upper and lower ball joint zerks. Adjustable 1/2" threaded rod to work on Camaro or Vette. A PIA to hold plumb in two directions while obtaining measurement.
0 2019/11/27 07:31:11
Toe bar held to wheel with magnets
Toe bar held to wheel with magnets
0 2019/11/27 05:48:03
Camber gauge added to toe bar
Camber gauge added to toe bar
0 2019/11/27 05:47:51
Infused LED lights in the original positions only
Infused LED lights in the original positions only
0 2019/11/20 07:14:44
In daylight with garage door open - brakes on LED infused red lights on outside & LED red bulbs inside with white brake light lenses.
In daylight with garage door open - brakes on LED infused red lights on outside & LED red bulbs inside with white brake light lenses.
0 2019/11/20 07:13:33
In daylight with garage door open - brakes not applied
In daylight with garage door open - brakes not applied
0 2019/11/20 07:13:02
0 2019/11/13 11:32:51
She taught him how to race.
She taught him how to race.
0 2019/11/11 16:09:25
Hard times deserve rest.
Hard times deserve rest.
0 2019/11/11 16:08:57
Moments I missed.
Moments I missed.
0 2019/11/11 16:08:48
0 2019/11/08 14:46:08
There is no glue on it. There are light indentations on one side that look like arrows point outward.
There is no glue on it. There are light indentations on one side that look like arrows point outward.
0 2019/11/06 05:57:36
It is about 1-1/2" x 2-1/4" foam about 1/16" thick.
It is about 1-1/2" x 2-1/4" foam about 1/16" thick.
0 2019/11/06 05:57:23
GM stamp and no key code. I have never seen one cut like this.
GM stamp and no key code. I have never seen one cut like this.
0 2019/11/03 08:49:39
Briggs and Straton B key looks to be maybe a blank? or master?
Briggs and Straton B key looks to be maybe a blank? or master?
0 2019/11/03 08:49:35
Old M/T valve covers with C2 flare.
Old M/T valve covers with C2 flare.
0 2019/10/30 17:28:36
Almost final covers for R66. If Grandma is happy so is everyone. Also have a good cover for hot adjustment of valves.
Almost final covers for R66. If Grandma is happy so is everyone. Also have a good cover for hot adjustment of valves.
0 2019/10/27 13:43:25
0 2019/10/27 13:41:52
68 RS Camaro
68 RS Camaro
0 2019/10/27 13:41:23
0 2019/10/27 13:40:46
These came from he hub covers on a 78 - 80s El Camino I think. The reproductions look real cheap. Any ideas?
These came from he hub covers on a 78 - 80s El Camino I think. The reproductions look real cheap. Any ideas?
0 2019/10/26 06:30:52