Tag: electronics
You will benefit from this tech tip if: 1. Your Bose system does a loud �POP� when you power it off, or � 2. Your Bose system continues to �BUZZ� even when you power it off, or� 3. Your Bose system �BUZZ� now becomes a loud and constant �HISS� even when the system is powered […] More »
1. Place transmitter and any optional transmitter 10 feet or more away from the car. 2. Turn the ignition key to the ON position. 3. Push the TRIP/ODO button on the DIC twice. 4. Within 5 Seconds, push and hold the FUEL/INFO button on the DIC until the PKE light on the DIC comes on […] More »
Antenna Bypass Switch 1984-96 My car 1992 A4 Coupe Materials List 1- Toggle switch 2- Crimp connectors (for switch) 8 ft of 16 ga. wire 2- 16 ga. butt connectors (blue) Heat shrink tube I got all this stuff for less than 10 dollars Remove or Disconnect Battery Pass seat & base Console door Console […] More »
The engine in my 93 is basically stock, and I do not foresee my going into the motor in the near future. The main reason I wanted to change the Eprom was to lower the temperature at which the cooling fans turned on, I did not like the factory setting of 226�, and to raise […] More »
How to correctly and inexpensively correct the ‘Inf Rest’ light on 1990 Corvettes. The 90 is infamous for this light staying on. It seems that there are two sensors, one on the frame underneath the battery box, and one underneath the windshield washer container. Both bolt directly to the frame. These little electronic wizards detect […] More »
Due to several e-mail inquiries, here are the instructions for removing the power antenna motor for service BEFORE installing a new antenna mast on 1992-1996 Corvettes. Many owners (myself included) have tried in vain to simply install a new antenna ribbon without inspecting the motor first for broken sections of the old one. The usual […] More »
T his information came from Alan Barbic (California Quicksilver) I also went through the same frustration in the \”great search\” for the elusive three wired connector. You are not delusional.. It was not in my 98 vert either. I went over the wiring diagrams in the factory service manuals and was able to establish the […] More »
All times are GMT -4. The time now is 08:52 PM.