Header side pipe inserts
#1
Header side pipe inserts
Can anyone out there tell me how the resonator inserts are installed. Do they just lay in the side pipe? My OBX header side pipes are not resonated because they were out of that type. Thought it would be easy to do. I have tried Google & all I keep getting is how to install the side pipes. One site told me I had to weld them in place. Can a member w/common sense please help me?
The following users liked this post:
Red Hot 71 (01-14-2019)
#3
Drifting
I used some from Classic Chambered Exhaust a few years back and they slipped into the tube with a slightly snug fit if this is what you're looking for. Never welded into place in case I need to remove
The following users liked this post:
Red Hot 71 (01-14-2019)
#4
Le Mans Master
Side pipe inserts typically just drop in to the side tubes before you attach them to the discharge ends of the header collector, . STS makes some good ones. Not cheap but they are popular around here.
The following users liked this post:
Red Hot 71 (01-14-2019)
#6
Drifting
Not sure how the OBX inserts attach but when I had Doug's inserts, they just drop in and they wedge themselves in, you just tap them in with a wood block. When it came time to remove them several months later they came back out again with a little tapping with a wood block, or maybe I just tapped the sidepipe on wood. The STS baffles are different in that they have two tabs with weld nuts. You match drill the sidepipe to those holes, then slide in the baffle, then bolt them in using red Loctite.