does anyone know... (wiring)
Thread Starter
Racer
Joined: Jun 2001
Posts: 435
Likes: 0
From: How did I get here? AZ
does anyone know... (wiring)
I am having trouble figuring out what wires are going to the plug on the shifter (auto). It is a 6 wire flat connector, labeled a b c d e f. i would think one of them is for the reverse lights, maybe one for the computer ffor lock up? not sure on this....can anyone give me a hand? A wiring diagram would be helpful ;) ......TIA
Racer
Joined: Jan 2003
Posts: 321
Likes: 0
From: Birmingham AL
Re: does anyone know... (want2drivemy85)
Hey my 85 diagram is not very user friendly. Could you give me the colors associated with the plugs and I will try to check on the diagram.
Is E dark green with a white stripe and F yellow ?????
Let me know.... Jim
Is E dark green with a white stripe and F yellow ?????
Let me know.... Jim
Thread Starter
Racer
Joined: Jun 2001
Posts: 435
Likes: 0
From: How did I get here? AZ
Re: does anyone know... (jimswhite92)
Thanks for the responses! ok here goes..
a= black with white stripe
b= orange with black stripe
c= blue
d=lite green
e= drk green with white stripe
f= yellow
BTW i need to figure this out because i am swapping the auto out in favor of a 4+3, and need to get all the wiring straightened out.
[Modified by want2drivemy85, 9:09 PM 3/15/2003]
a= black with white stripe
b= orange with black stripe
c= blue
d=lite green
e= drk green with white stripe
f= yellow
BTW i need to figure this out because i am swapping the auto out in favor of a 4+3, and need to get all the wiring straightened out.
[Modified by want2drivemy85, 9:09 PM 3/15/2003]
Race Director
Joined: Aug 2002
Posts: 17,367
Likes: 1
From: Kentucky
Re: does anyone know... (want2drivemy85)
According to an 88 wiring diagram on an auto the DK BLU goes from the backup fuse to the transmission position switch and the LT GRN goes from the position switch to the backup lights.
[Modified by hngacurv, 11:12 PM 3/15/2003]
[Modified by hngacurv, 11:12 PM 3/15/2003]
- 1986 Original Owner -
Joined: Apr 1999
Posts: 3,193
Likes: 139
From: North Yorkshire, England
Cruise-In I Veteran
Cruise-In II Veteran
Cruise-In III Veteran
Cruise-In IV Veteran
Cruise-In VII Veteran
Re: does anyone know... (want2drivemy85)
Pin A is the black with white stripe and goes to ground at splice S212.
Pin B is the orange with black stripe and goes to the ECM pin B10. A and B make when in Park or Neutral. Not used in manuals.
Pin C is dark blue and goes to the TURN/BU fuse as said by hngacurv.
Pin D is lite green and goes to the lights as said by hngacurv. C and D make when in Reverse. These will need to be wired in to the 2 cavity connector (12015378) that will plug into your new 4+3s backup switch.
Pin E is drk green with white stripe and goes to pin A of the Start Enable Relay.
Pin F was I thought purple not yellow, but it should go to the S terminal on the solenoid and to the Cold Start Injector system through splice S206. E and F make when in Park or Neutral. These will need to go to the Clutch Switch so the starter will only run when the clutch pedal is depressed or you can connect them together and lose the safety feature. But ring this one out first, because of the color mixup, I can't be sure on this one.
Pin B is the orange with black stripe and goes to the ECM pin B10. A and B make when in Park or Neutral. Not used in manuals.
Pin C is dark blue and goes to the TURN/BU fuse as said by hngacurv.
Pin D is lite green and goes to the lights as said by hngacurv. C and D make when in Reverse. These will need to be wired in to the 2 cavity connector (12015378) that will plug into your new 4+3s backup switch.
Pin E is drk green with white stripe and goes to pin A of the Start Enable Relay.
Pin F was I thought purple not yellow, but it should go to the S terminal on the solenoid and to the Cold Start Injector system through splice S206. E and F make when in Park or Neutral. These will need to go to the Clutch Switch so the starter will only run when the clutch pedal is depressed or you can connect them together and lose the safety feature. But ring this one out first, because of the color mixup, I can't be sure on this one.
Thread Starter
Racer
Joined: Jun 2001
Posts: 435
Likes: 0
From: How did I get here? AZ
Re: does anyone know... (jimswhite92)
Ray- Thanks, thats the kind of stuff i was looking for!
Jim- If you could email me a schematic, i would be very greatful! Much easier to do this with a diagram in front of you.
Thanks again all!
Jim- If you could email me a schematic, i would be very greatful! Much easier to do this with a diagram in front of you.
Thanks again all!
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
