airbridge question
Thread Starter
Intermediate
Joined: Feb 2004
Posts: 36
Likes: 3
From: kennett square pa
airbridge question
i know this is a dumb question.(i am new) how the heck do i separate the airbridge from the mas?i loosened the clamp, but what else do i have to do? the two just don't want to separate.
Le Mans Master
Joined: Jun 2003
Posts: 9,251
Likes: 217
From: 2007 Nat'l Corvette Challenge 11.50 index Champ. New Jersey
Try getting a screwdriver blade under the edges carefully (as to not tear it)...If not, you may have to remove your air box, then pull off the air bridge.
Ron
Ron
Race Director
Joined: Dec 2000
Posts: 19,304
Likes: 85
From: San Diego CA
Check out my Halltech Stinger-R installation procedures for tips on removing the MAF:
http://www.conceptualpolymer.com/corvette_c5_corner.htm
http://www.conceptualpolymer.com/corvette_c5_corner.htm
Tech Contributor
Joined: Dec 1999
Posts: 32,910
Likes: 2,402
From: Anthony TX
CI 6,7,8,9,11 Vet
St. Jude Donor '08
ALWAYS remove the air box from the car to work on it! It makes life MUCH easier!! 
It is only held on by two pins in the front of the box, two rubber gromets on the radiator shroud and the clamp on the throttle body!
BC
It is only held on by two pins in the front of the box, two rubber gromets on the radiator shroud and the clamp on the throttle body!BC
