"How to" for drill mod??
#41
Le Mans Master
Member Since: Dec 2006
Location: Phoenix Arizona
Posts: 7,251
Likes: 0
Received 14 Likes
on
14 Posts
Would say so. At 30 degrees the viscosity of dot3 or 4 will be much thicker. If there is a restriction I could see this being the problem. My car had a new master slave clutch, pressure plate and flywheel installed 10k ago and has stuck ever since the hci mods. I will be replacing the clutch and hydraulics soon and fully plan on thedrillmod. I don't plan on having to disassemble this again and see no harm.
Any objections?
Any objections?